Valcom v 2003 manual

Architectural wiring diagrams exploit the approximate locations and interconnections of receptacles, lighting, and long-lasting electrical facilities in a building. Interconnecting wire routes may be shown approximately, where particular receptacles or fixtures must be on a common circuit.

Wiring diagrams use pleasing symbols for wiring devices, usually every other from those used upon schematic diagrams.

The electrical symbols not on your own acquit yourself where something is to be installed, but after that what type of device is subconscious installed. For example, a surface ceiling blithe is shown by one symbol, a recessed ceiling light has a substitute symbol, and a surface fluorescent buoyant has substitute symbol. Each type of switch has a different fable and for that reason complete the various outlets.

There are symbols that piece of legislation the location of smoke detectors, the doorbell chime, and thermostat. Okay, so the pa-1 is configured as a standard extension on the QX, and a route is defined in the CRT for dialing the snom extension. The snom registers locally using a single identity. There is nothing at all special on the extension--it is assigned an IP line just like any other IP phone.

The snom pa1 has several action URLs that can programmed based on the events taking place with the device. We used the 'On Connected', and 'On Disconnnected' events. Using this, the snom pa-1 receives a phone call from any extension, the action url applies 3.

And we have 22 speakers broadcasting in our new paging system. Hope this helps somebody else save hours of research time Last edited by tchancev; at PM. Thanks for your post, but could you provide detail on how to connect the pa1 to the Valcom?

I am trying to get this going with a Valcom which I think is very similar. Exactly which physical wires are going to where on the Valcom? On the input side of the Valcom I have two connections for Music - and these certainly work for an external music source. But not for the SNOM Are there other connections that need to be made as well? Thank you so much in advance!

Originally Posted by tchancev. Last edited by jontron11; at AM.